A sugar-free fibre gummy carries two claims on the front and one number in the nutrition panel that decides whether either of them survives: the sugar figure, per 100 g, measured at the end of shelf life.
The fibre and the sugar-free claim are usually designed together and then undone together, because the acid that sets the gel is the acid that breaks the fibre down into sugar.

Fibre is a bulking agent before it is a nutrient
Remove sugar from a gummy and something has to take its place. Sucrose and glucose syrup do two jobs in the formula: they sweeten, and they provide the bulk and the body that make the piece chew like a gummy.
Intense sweeteners do only the first. Stevia, sucralose and monk fruit bring sweetness with no mass, so the mass has to come from somewhere else. Polyols take part of it, and soluble fibre takes the rest.
That is why fibre appears in these products at all. A 3 g piece that would have been 55 per cent sugar syrup has to be 55 per cent of something, and a soluble fibre like polydextrose or resistant dextrin fills that role with a fraction of the calories and without raising blood glucose.
The nutritional claim comes afterwards, as a consequence of how much bulking agent the piece needed. Which is the reverse of how the brief usually reads.
Two thresholds and a piece of arithmetic
The EU conditions are simple. A food is a source of fibre at 3 g per 100 g or 1.5 g per 100 kcal, and high in fibre at 6 g per 100 g or 3 g per 100 kcal.
Run a three gram piece through the first threshold. Six grams per 100 g means 0.18 g of fibre per piece. Six pieces of that size would deliver just over a gram of fibre, which is a third of what a slice of wholemeal bread carries.
The per-100-kcal route is easier still, because a sugar-free gummy is low in energy — a three gram piece is roughly 6 to 8 kcal, so 3 g per 100 kcal is about 0.2 g per piece. Both routes are passed by a piece carrying around 6 to 7 per cent fibre by weight.
So the claim is easy and the dose is not. A piece carrying enough fibre to matter — 1 g or more — is 33 per cent fibre by weight, and at that load the fibre is holding water, the texture turns to jelly, and the piece stops being a gummy at all. The realistic ceiling is 10 to 15 per cent, which is 300 to 450 mg per piece, and that is what most products on the shelf actually contain whether or not the panel implies otherwise.
Where the pH collides
High-methoxyl pectin gels at a pH below about 3.5, in the presence of sugar at 55 per cent or more. Sugar-free removes the sugar, which is why sugar-free pectin gummies use a low-methoxyl pectin and set on calcium instead — but the acid is still there, because the flavour needs it and because a low pH helps the set.
Inulin, the most common prebiotic fibre, is stable at pH 5 to 7 and starts to hydrolyse below pH 4. The hydrolysis releases fructose and glucose — the two sugars the product has promised not to contain.
The rate depends on temperature, time, water content and pH, and it is slower in a gel than in solution. It is not zero. A piece sitting at pH 3.5 for a year at ambient temperature is a piece in which some fraction of the inulin has become free sugar, and the "sugar-free" claim, which requires less than 0.5 g per 100 g, is measured on the finished product at the end of its life.
That is the collision. The same acid that makes the gummy set and taste right is the acid that eats the fibre and feeds the sugar number.
The ways around it are all compromises:
- A higher pH. Move to 4.2 to 4.5 with a low-methoxyl pectin and a calcium set, accept a slower set and a softer bite.
- A different fibre. Polydextrose and resistant dextrin are far more acid-stable than inulin. They are also less convincing as prebiotics, because the evidence base sits with inulin and oligofructose.
- Less acid, more flavour. Build the flavour on non-acid notes and use a buffering system, which narrows the flavour options considerably.
- Test at the end. Whatever the route, the sugar figure has to be measured on stored product, not on the batch sheet.
The polyol account
Sugar-free gummies are usually built on maltitol, sorbitol, isomalt or erythritol, often in combination.
Two things follow from that. The first is a labelling obligation: foods containing more than 10 per cent added polyols must state that excessive consumption may produce laxative effects. A gummy at 50 per cent polyol is well past that line, and the statement goes on the pack in every member state.
The second is the calorie and glycaemic arithmetic that the "sugar-free" claim implies but does not state. Maltitol is around 2.1 kcal per gram and has a glycaemic response; erythritol is around 0.2 kcal per gram and effectively none. A piece built on maltitol is not the same product, nutritionally, as one built on erythritol, even though both can print the same sugar figure of zero.
Erythritol has its own constraint: it is only about 70 per cent as sweet as sucrose and it brings a cooling effect, which reads well in mint and poorly in caramel. It also has a lower solubility limit, which matters at high inclusion in a low-moisture piece.
The three fibres, and what each does to the line
- Inulin and oligofructose. The best prebiotic evidence, the weakest acid stability, and a tendency to foam. Dosage above 10 per cent brings digestive tolerance issues that the laxative statement only partly covers.
- Polydextrose. Acid-stable, low calorie, good bulking, and it carries a fibre claim without a prebiotic one. It is the workhorse of the category for that reason.
- Resistant dextrin. Low viscosity, neutral taste, acid-stable, and it does not foam. It is the easiest to run and the least interesting on the front panel.
A blend is common: polydextrose for bulk and stability, a smaller amount of inulin so the word prebiotic can appear. The ratio is set by how much acid the flavour system needs, which is set by the flavour, which is set by the market.
What a 500 kg batch settles
Five hundred kilograms at three grams is about 166,000 pieces. At 12 per cent fibre that is 60 kg of fibre for the batch; at 7 per cent, the minimum for a per-100 g claim, it is 35 kg.
The difference between those two figures is the whole commercial argument about whether the product is a fibre product or a sugar-free gummy that happens to contain fibre. Both can print the claim. Only one of them does anything.
The batch also has to fix the polyol, because the polyol sets the laxative statement, the calorie figure and the texture, and changing it late changes all three. And it has to fix the sugar test method, because a method that measures only sucrose and glucose will miss the fructose released by inulin hydrolysis and will report a product as sugar-free that is drifting.
For buyers comparing formats, the functional gummies line is where piece weight and bulking system are set together, and the sugar-free process side is described under sugar-free gummy manufacturing. The assay and stability side sits under gummy quality control testing.
Ding Shaohua, Foreign Trade Manager at WANHUACAO, works with brands and distributors on functional gummy programmes from brief to first shipment, in bulk and in private label, including sugar-free, polyol and fibre-fortified formulas. The plant operates under SGS CN23/00007035 for gel confectionery and SC11434160205012 covering eight dosage forms, sports nutrition supplements among them. Reach him on WhatsApp, TikTok, LinkedIn and Facebook.
FAQ
How much fibre can a gummy actually carry?
10 to 15 per cent of the piece weight, so 300 to 450 mg in a three gram gummy. Above that the fibre holds water, the texture turns soft and jelly-like, and the piece stops reading as a gummy. The claim threshold is far below that, which is why so many products claim fibre and deliver very little.
Why does inulin cause a problem in a sugar-free gummy?
Inulin is stable at pH 5 to 7 and hydrolyses below pH 4, releasing fructose and glucose. A pectin gummy is set at an acid pH, so the fibre is slowly turning into the sugar the product claims not to contain, and the sugar figure is measured at the end of shelf life.
Which fibre is most acid-stable?
Polydextrose and resistant dextrin. Both hold up far better than inulin in an acid gel, and both are easier to run. Neither carries the prebiotic evidence that inulin and oligofructose do, which is why blends are common.
Does a sugar-free gummy need a laxative warning?
Yes, if it contains more than 10 per cent added polyols. At the polyol levels a gummy needs to replace sugar, the statement is mandatory in the EU, and it goes on the pack in every member state.
Is erythritol interchangeable with maltitol?
No. Erythritol is about 0.2 kcal per gram with effectively no glycaemic response and a cooling taste; maltitol is around 2.1 kcal per gram with a glycaemic response. Both can print a sugar figure of zero, and they are different products nutritionally.
